介绍

Banana PI BPI-M2 Ultra

Overview: BPI-M2 with R40 chip

Overview: BPI-M2 with A40i chip

Overview: BPI-M2 with V40 chip

File:M2 M64 Ultra case 3.JPG

BPI-M2 Ultra Premium Aluminum Enclosure

BPI-M2 Ultra acrylic case

BPI-M2 Ultra for BPI 4.0 Successful case ：R40 for vehicle license plate recognition

BPI-M2 Ultra for BPI 4.0 Successful case ：R40 for IoT gateway with Z-wave, zigbee,WiFI

香蕉派 BPI-M2 Ultra 四核单板计算机采用全志 R40芯片开发。支持板载Wifi与蓝牙，支持SATA接口，可以直接接硬盘。并且板载8G eMMC ,可以选择SD卡启动或从eMMC flash 启动。

Banana PI BPI-M2 Ultra 兼容性强大,可以跑android系统,Debian linux,Ubuntu linux, Raspberry Pi系统和全志Tina 系统.

Banana PI BPI-M2 Ultra硬件：全志R40 四核处理器，2GB LPDDR3内存，千兆以太网口，3USB 接口流畅运行Android5.1。Banana PI BPI-M2 Ultra 体积如信用卡大小，与BPI-M3尺寸一样，GPIO兼容Raspberry PiB+并能运行其ROM Image。

File:BPI-M2 Ultra a.JPG

关键特性

全志R40/V40 Quad Core ARM Cortex A7 CPU
2GB DDR3 SDRAM.
8GB eMMC flahs onboard.
WiFi (AP6212) & Bluetooth onboard.
SATA Interface.
2*USB 2.0
MIPI DSI ingerface
CSI camera interface

开始使用

Quick Start Banana pi SBC

Getting Start with M2 Ultra / Berry

硬件

硬件接口图

File:BPI-M2 Ultra interface.jpg

硬件规格

香蕉派 BPI-M2 Ultra硬件规格书
主芯片	Allwinner R40/V40
CPU主控	quad-core cortex -A7,the most power efficient CPU core ARM's ever development
GPU	dual-core MALI-400 MP2 and runs at 500MHz, capable of 1.1 Gpixel/s throughput. Graphics capabilities are slightly higher than the original Xbox’s level of performance. The GPU provides OpenGL ES 2.0, hardware-accelerated OpenVG, 1080p45 H.264 high-profile encode and decode.
SDRAM内存	2 GB DDR3 with 733MHz\(shared with GPU\)
SATA 硬盘接口	suppoort SATA interface
GPIO定义	40 Pins Header, 28×GPIO, some of which can be used for specific functions including UART, I2C, SPI, PWM, I2S.
有线网口	10/100/1000Mbps Ethernet \(Realtek RTL8211E/D\)
Wifi 无线	WiFi 802.11 b/g/n \(AP 6212 module on board\)
蓝牙支持	BT4.0
Flash存储	MicroSD \(TF\) card,8GB eMMC onboard
显示	4-lane MIPI DSI display,or RGB panel or LVDS panel,TV-out on HDMI V1.4
Video	Multi-format FHD video decoding, including Mpeg1/2, Mpeg4, H.263, H.264, etc H.264 decode up to 1080P60,support video encodeing:High-deinition\(HD\)H.264 video encoder is up to 1080P@45fps
Audio outputs	HDMI, analog audio \(via 3.5 mm TRRS jack\)
Camera摄像头	A CSI input connector Camera:Supports 8-bit YUV422 CMOS sensor interface,Supports CCIR656 protocol for NTSC and PAL,Supports 5M pixel camera sensor ,Supports video capture solution up to 1080p@30fps
Audio input	On board microphone
USB	2 USB 2.0 host, 1 USB 2.0 OTG
按键	Reset button, Power button, U-boot button
Led 灯	Power status Led and RJ45 Led
IR红外控制	onboard IR receiver
DC 供电	5V/2A with micro USB port
电池接口	3.7V lithium battery power support
尺寸	85mmX56mm,same size as raspberry pi 3
Weight	40g

GPIO PIN 定义

香蕉派BPI-M2 Ultra 支持40-pin GPIO 接口，定义兼容树莓派3. GPIO定义如下:

香蕉派BPI-M2 Ultra 40-pin GPIO 接口定义
GPIO Pin Name	Default Function	Function2：GPIO	Function3
CON1-P01	VCC-3V3
CON1-P02	DCIN
CON1-P03	TWI2-SDA	PB21	PWM5
CON1-P04	DCIN
CON1-P05	TWI2-SCK	PB20	PWM4
CON1-P06	GND
CON1-P07	PB3	PB3	PWM1
CON1-P08	UART2-TX	PI18	SPI1\_MOSI
CON1-P09	GND
CON1-P10	UART2-RX	PI19	SPI1\_MISO
CON1-P11	UART7-TX	PI20	PWM2
CON1-P12	UART2-CTS	PI17	SPI1\_CLK
CON1-P13	UART7-RX	PI21	PWM3
CON1-P14	GND
CON1-P15	PH25	PH25	CSI1-FIELD
CON1-P16	UART2-RTS	PI16	SPI1\_CS0
CON1-P17	VCC-3V3
CON1-P18	PH26	PH26	CSI1-HSYNC
CON1-P19	SPI0\_MOSI	PC0
CON1-P20	GND
CON1-P21	SPI0\_MISO	PC1
CON1-P22	PH27	PH27	CSI1-VSYNC
CON1-P23	SPI0\_CLK	PC2
CON1-P24	SPI0\_CS	PC23
CON1-P25	GND
CON1-P26	PH24	PH24	CSI1-PCLK
CON1-P27	TWI3-SDA	PI1
CON1-P28	TWI3-SCK	PI0
CON1-P29	PH0	PH0	CSI1-D0
CON1-P30	GND
CON1-P31	PH1	PH1	CSI1-D1
CON1-P32	PD20	PD20	CSI1-MCLK
CON1-P33	PH2	PH2	CSI1-D2
CON1-P34	GND
CON1-P35	PH3	PH3	CSI1-D3
CON1-P36	UART5-RX	PH7	CSI1-D7
CON1-P37	UART4-TX	PH4	CSI1-D4
CON1-P38	UART5-TX	PH6	CSI1-D6
CON1-P39	GND
CON1-P40	UART4-RX	PH5	CSI1-D5

CSI Camera 摄像头接口规格:

The CSI Camera Connector is a 24-pin FPC connector which can connect external camera module with proper signal pin mappings. The pin definitions of the CSI interface are shown as below. This is marked on the Banana Pi board as “Camera”.

BPI-M2 Ultra CSI 摄像头 GPIO 定义
CSI Pin Name	Default Function	Function2：GPIO
CN5-P01	NC
CN5-P02	GND
CN5-P03	CSI0-SDA	PI3
CN5-P04	CSI0-AVDD
CN5-P05	CSI0-SCK	PI2
CN5-P06	CSI0-Reset	PI7
CN5-P07	CSI0-VSYNC	PE3
CN5-P08	CSI0-PWDN	PI6
CN5-P09	CSI0-HSYNC	PE2
CN5-P10	CSI0-DVDD
CN5-P11	CSI0-DOVDD
CN5-P12	CSI0-D7	PE11
CN5-P13	CSI0-MCLK	PE1
CN5-P14	CSI0-D6	PE10
CN5-P15	GND
CN5-P16	CSI0-D5	PE9
CN5-P17	CSI0-PCLK	PE0
CN5-P18	CSI0-D4	PE8
CN5-P19	CSI0-D0	PE4
CN5-P20	CSI0-D3	PE7
CN5-P21	CSI0-D1	PE5
CN5-P22	CSI0-D2	PE6
CN5-P23	GND
CN5-P24	CSI0-AFVCC

MIPI屏显示接口规格

MIPI DSI \(Display Serial Interface\)

The display Connector is a 40-pin FPC connector which can connect external LCD panel \(MIPI DSI\) and touch screen \(I2C\) module as well. The pin definitions of this connector are shown as below. This is marked on the Banana Pi board as “DSI”.

40 PIN GPIO of Banana pi BPI-M2 Ultra
DSI Pin Name	Default Function	Function2：GPIO
CN6-P01	VCC-3V3
CN6-P02	IPSOUT
CN6-P03	VCC-3V3
CN6-P04	IPSOUT
CN6-P05	GND
CN6-P06	IPSOUT
CN6-P07	GND
CN6-P08	IPSOUT
CN6-P09	NC
CN6-P10	GND
CN6-P11	NC
CN6-P12	DSI-D0N
CN6-P13	NC
CN6-P14	DSI-D0P
CN6-P15	NC
CN6-P16	GND
CN6-P17	TWI0-SDA	PB19
CN6-P18	DSI-D1N
CN6-P19	TWI0-SCK	PB18
CN6-P20	DSI-D1P
CN6-P21	CTP-INT	PI10
CN6-P22	GND
CN6-P23	CTP-RST	PI11
CN6-P24	DSI-CKN
CN6-P25	GND
CN6-P26	DSI-CKP
CN6-P27	LCD-BL-EN	PH16
CN6-P28	GND
CN6-P29	LCD-RST	PH17
CN6-P30	DSI-D2N
CN6-P31	LCD-PWR-EN	PH18
CN6-P32	DSI-D2P
CN6-P33	GND
CN6-P34	GND
CN6-P35	LCD-PWM	PB2
CN6-P36	DSI-D3N
CN6-P37	GND
CN6-P38	DSI-D3P
CN6-P39	NC
CN6-P40	GND

UART specification:

The header CON4 is the UART interface. For developers of Banana Pi, this is an easy way to get the UART console output to check the system status and log message.