Getting Started with BPI-R4

From Banana Pi Wiki
Revision as of 23:58, 19 October 2023 by Sinovoip (talk | contribs) (→‎10G SFP+ Copper Module)
Jump to: navigation, search

Development

Basic Development

Prepare to develop

 * Prepare 8G/above TF card, USB-Serial cable, Ubuntu System
 * Using your USB-Serial cable Connect to debug console on BPI-R4
    R4 DebugPort.png

 * BPI-R4 bootstrap and device select Jumper Setting
    R4-bootstrip.png



  * Examples:

 1. All Jumper is "1", BPI-R4 will boot from SD card
    R4 SDBOOT.png



 2. SW3-A is "0" and SW3-B is "1" , BPI-R4 will boot from SPI NAND
    R4 NANDBOOT.png



 3. SW3-A is "1" and SW3-B is "0" , BPI-R4 will boot from eMMC
    R4 eMMCBOOT.png

Accessories

1. 10G SFP Module

The SFP serdes of BPI-R4 requesting link mode inband/10gbase-kr, so only SFP that support this protocol can be used！

10G SFP+ Copper Module

SFP-10G-T-AQR.png

BPI-R4 SFP-10G-T(AQR113C).png


Note:

The temperature of this module is very high when used for a long time, and can reach 90°C. Be careful to prevent burns.

Do not pull out this module once it is inserted, otherwise it will cause BPI-R4 to reboot.This phenomenon does not exist with other modules.

BPI-R4 SFP-10G-T(AQR113C)-Pull out reboot.png

10G SFP+ Fibre Module

SFP-10G-BX20.png

BPI-R4 SFP-10G-BX20.png

2. 4G/5G Module

3. SSD

4. Asia mPCIe WiFi6/WiFi6E

Retrieved from "https://wiki.banana-pi.org/index.php?title=Getting_Started_with_BPI-R4&oldid=16288"