Difference between revisions of "Getting Started with BPI-R4"
(→Prepare to develop) |
(→Prepare to develop) |
||
Line 6: | Line 6: | ||
* Prepare 8G/above TF card, USB-Serial cable, Ubuntu System | * Prepare 8G/above TF card, USB-Serial cable, Ubuntu System | ||
* Using your USB-Serial cable Connect to debug console on BPI-R4 | * Using your USB-Serial cable Connect to debug console on BPI-R4 | ||
+ | G=Groung; RX=BPI-R4 input; TX=BPI-R4 output | ||
[[File:R4 DebugPort.png|320px]] | [[File:R4 DebugPort.png|320px]] | ||
Revision as of 02:46, 21 November 2023
Contents
Development
Basic Development
Prepare to develop
* Prepare 8G/above TF card, USB-Serial cable, Ubuntu System * Using your USB-Serial cable Connect to debug console on BPI-R4 G=Groung; RX=BPI-R4 input; TX=BPI-R4 output![]()
* BPI-R4 bootstrap and device select Jumper Setting![]()
* Examples:
1. All Jumper is "1", BPI-R4 will boot from SD card![]()
2. SW3-A is "0" and SW3-B is "1" , BPI-R4 will boot from SPI NAND![]()
3. SW3-A is "1" and SW3-B is "0" , BPI-R4 will boot from eMMC![]()
4. If the console said "system halt!", it means that the bootup storage does not cotain any OS![]()
Accessories
1. 10G SFP Module
The SFP serdes of BPI-R4 requesting link mode inband/10gbase-kr, so only SFP that support this protocol can be used!
Usually the PIN6 of 10G SFP+ module is GND. After inserting the module, SFP_MOD_DEF0 will be pulled low, thereby turning on the SFP power supply.
Therefore, if this PIN of the module is not GND, 3.3V_SFP power will not be supplied!
10G SFP+ Copper Module
The temperature of this module is very high when used for a long time, It can reach 90℃ without a heat sink or cooling fan. Be careful to prevent burns!
Note:
Do not pull out this module once it is inserted, otherwise it will cause BPI-R4 to reboot.This phenomenon does not exist with other modules.