Getting Started with BPI-R4: Difference between revisions
Jump to navigation
Jump to search
| Line 14: | Line 14: | ||
* Using your USB-Serial cable Connect to debug console on BPI-R4 | * Using your USB-Serial cable Connect to debug console on BPI-R4 | ||
[[File:R4 DebugPort.png]] | [[File:R4 DebugPort.png|320px]] | ||
* BPI-R4 bootstrap and device select Jumper Setting | * BPI-R4 bootstrap and device select Jumper Setting | ||
[[File:R4-bootstrip.png|320px | [[File:R4-bootstrip.png|320px]] | ||
Note: SW1-A and SW1-B is for boot strap selecting; | Note: SW1-A and SW1-B is for boot strap selecting; | ||
Revision as of 08:49, 25 September 2023
Introduction
MediaTek MT7986(Filogic 830)
Key Features
Development
Basic Development
Prepare to develop
* Prepare 8G/above TF card, USB-Serial cable, Ubuntu System * Using your USB-Serial cable Connect to debug console on BPI-R4
* BPI-R4 bootstrap and device select Jumper Setting
Note: SW1-A and SW1-B is for boot strap selecting;
SW1-C is that SPI-Nand or SPI-Nor Device is connected to CPU's SPI bus;
SW1-D is that SD Card or EMMC device is connected tp CPU's EMMC bus.
* Examples:
All Jumper is High.
All Jumper is Low.
