Difference between revisions of "Getting Started with BPI-R4"
(→Accessories) |
(→1. 10G SFP Module) |
||
| Line 37: | Line 37: | ||
The SFP serdes of BPI-R4 requesting link mode '''inband/10gbase-kr''', so only SFP that support this protocol can be used！ | The SFP serdes of BPI-R4 requesting link mode '''inband/10gbase-kr''', so only SFP that support this protocol can be used！ | ||
| − | ====10G SFP+ Copper==== | + | ====10G SFP+ Copper Module==== |
| Line 50: | Line 50: | ||
| − | ====10G SFP+ Fibre==== | + | ====10G SFP+ Fibre Module==== |
[[File:SFP-10G-BX20.png|500px]] | [[File:SFP-10G-BX20.png|500px]] | ||
Revision as of 19:09, 7 October 2023
Contents
Introduction
MediaTek MT7986(Filogic 830)
Key Features
Development
Basic Development
Prepare to develop
* Prepare 8G/above TF card, USB-Serial cable, Ubuntu System
* Using your USB-Serial cable Connect to debug console on BPI-R4
* BPI-R4 bootstrap and device select Jumper Setting
* Examples:
1. All Jumper is "1", BPI-R4 will boot from SD card
2. SW3-A is "0" and SW3-B is "1" , BPI-R4 will boot from SPI NAND
3. SW3-A is "1" and SW3-B is "0" , BPI-R4 will boot from eMMC
Accessories
1. 10G SFP Module
The SFP serdes of BPI-R4 requesting link mode inband/10gbase-kr, so only SFP that support this protocol can be used！
10G SFP+ Copper Module
.png)
Note: Do not pull out this module once it is inserted, otherwise it will cause BPI-R4 to reboot.
-Pull_out_reboot.png)
10G SFP+ Fibre Module
