Revision as of 18:32, 7 October 2023

Introduction

 * Prepare 8G/above TF card, USB-Serial cable, Ubuntu System
 * Using your USB-Serial cable Connect to debug console on BPI-R4

 * BPI-R4 bootstrap and device select Jumper Setting

  * Examples:

 All Jumper is "1", BPI-R4 will boot from SD card

 SW3-A is "0" and SW3-B is "1" , BPI-R4 will boot from SPI NAND

 SW3-A is "1" and SW3-B is "0" , BPI-R4 will boot from eMMC

The SFP serdes of BPI-R4 requesting link mode inband/10gbase-kr, so only SFP that support this protocol can be used！

Note: Do not pull out this module once it is inserted, otherwise it will cause BPI-R4 to reboot.

Revision as of 18:28, 7 October 2023 (view source) Sinovoip (talk \| contribs) (→‎1.10G SFP+ Module) ← Older edit		Revision as of 18:32, 7 October 2023 (view source) Sinovoip (talk \| contribs) (→‎2.4G/5G Module) Newer edit →
Line 58:		Line 58:

	===2.4G/5G Module===		===2.4G/5G Module===
−

	===3. SSD===		===3. SSD===