Difference between revisions of "Getting Started with BPI-R4"
(→1.10G SFP+ Copper) |
(→Accessories) |
||
| Line 57: | Line 57: | ||
[[File:BPI-R4 SFP-10G-BX20.png|500px]] | [[File:BPI-R4 SFP-10G-BX20.png|500px]] | ||
| − | |||
| + | ===2.4G/5G Module=== | ||
| − | |||
| + | ===3. SSD=== | ||
| − | === | + | |
| + | ===4. Asia mPCIe WiFi6/WiFi6E=== | ||
Revision as of 18:27, 7 October 2023
Contents
Introduction
MediaTek MT7986(Filogic 830)
Key Features
Development
Basic Development
Prepare to develop
* Prepare 8G/above TF card, USB-Serial cable, Ubuntu System
* Using your USB-Serial cable Connect to debug console on BPI-R4
* BPI-R4 bootstrap and device select Jumper Setting
* Examples:
All Jumper is "1", BPI-R4 will boot from SD card
SW3-A is "0" and SW3-B is "1" , BPI-R4 will boot from SPI NAND
SW3-A is "1" and SW3-B is "0" , BPI-R4 will boot from eMMC
Accessories
1.10G SFP+ Module
The SFP serdes of BPI-R4 requesting link mode inband/10gbase-kr, so only SFP that support this protocol can be used！
1.1. 10G SFP+ Copper
.png)
Note: Do not pull out this module once it is inserted, otherwise it will cause BPI-R4 to reboot.
-Pull_out_reboot.png)
1.2. 10G SFP+ Fibre
