Difference between revisions of "Getting Started with BPI-R4"
(→Accessories) |
(→Accessories) |
||
| Line 34: | Line 34: | ||
==Accessories== | ==Accessories== | ||
| − | 1.10G SFP+ Copper | + | ===1.10G SFP+ Copper=== |
[[File:SFP-10G-T-AQR.png|500px]] | [[File:SFP-10G-T-AQR.png|500px]] | ||
| Line 44: | Line 44: | ||
[[File:BPI-R4 SFP-10G-T(AQR113C)-Pull out reboot.png|500px]] | [[File:BPI-R4 SFP-10G-T(AQR113C)-Pull out reboot.png|500px]] | ||
| − | 2. 10G SFP+ Fibre | + | ===2. 10G SFP+ Fibre=== |
[[File:SFP-10G-BX20.png|500px]] | [[File:SFP-10G-BX20.png|500px]] | ||
| Line 50: | Line 50: | ||
[[File:BPI-R4 SFP-10G-BX20.png|500px]] | [[File:BPI-R4 SFP-10G-BX20.png|500px]] | ||
| − | 3.4G/5G Module | + | ===3.4G/5G Module=== |
Revision as of 18:07, 7 October 2023
Contents
Introduction
MediaTek MT7986(Filogic 830)
Key Features
Development
Basic Development
Prepare to develop
* Prepare 8G/above TF card, USB-Serial cable, Ubuntu System
* Using your USB-Serial cable Connect to debug console on BPI-R4
* BPI-R4 bootstrap and device select Jumper Setting
* Examples:
All Jumper is "1", BPI-R4 will boot from SD card
SW3-A is "0" and SW3-B is "1" , BPI-R4 will boot from SPI NAND
SW3-A is "1" and SW3-B is "0" , BPI-R4 will boot from eMMC
Accessories
1.10G SFP+ Copper
.png)
Note: Do not pull out the module once it is inserted, otherwise it will cause BPI-R4 to restart.
-Pull_out_reboot.png)
2. 10G SFP+ Fibre
3.4G/5G Module
4. SSD
5. Asia mPCIe WiFi6/WiFi6E
